| Screen Size |
1.78 – 25.4 m (70 inch – 1000 inch) |
| Display Type |
DLP Chip × 3 (R, G, B), DLP Projection System |
| Model Number |
PT-DZ16K2 |
| Brand |
Panasonic |
| Resolution |
1920 × 1080 pixel (Input Signals That Exceed This Resolution Will Be Converted to 1920 × 1080 pixel) |
| Power supply |
200 – 240 V AC, 12 A, 50/60 Hz (3-wire single-phase) |
| Power consumption |
2,060 W (2,100 VA) (0.3 W with STANDBY MODE set to ECO. 9Wwith STANDBY MODE set to NORMAL.), max. 7,031 BTU (without light output: 6,758 BTU ) |
| DLP chip - Panel size |
24.1 mm (0.95 inches) diagonal (16:9 aspect ratio) |
| DLP chip - Display method |
DLP chip × 3 (R, G, B), DLP projection system |
| DLP chip - Pixels |
2,073,600 (1,920 × 1,080) × 3, total of 6,220,800 pixels |
| Lens |
Optional powered zoom/focus lenses |
| Lamp |
432 W UHM lamps (× 4) (four lamp system) |
| Brightness |
432 W UHM lamps (× 4) (four lamp system) |
| Center-to-corner uniformity |
90% |
| Contrast |
10,000:1 (full on/full off, in dynamic iris 3 mode) |
| Scanning frequency - SDI |
3G-SDI signal (YPBPR 4:2:2 10-bit): SMPTE ST 424 compliant: 1080/50p, 1080/60p, (RGB4:4:4 12bit/10bit): SMPTE ST 424 compliant: 1080/50i, 1080/60i, 1080/25p, 1080/24p 1080/24sF, 1080/30p Single-link HD-SDI signal (YPBPR 4:2:2 10-bit): SMPTE ST 292 compliant: 720/50p, 720/60p, 1035/60i, 1080/50i, 1080/60i, 1080/25p, 1080/24p, 1080/24sF, 1080/30p SD-SDI signal (YCBCR 4:2:2 10-bit): SMPTE ST 259 compliant: 480i, 576i |
| Scanning frequency - HDMI/DVI-D/ DIGITAL LINK/RGB |
Horizontal: 15 –100 kHz, vertical: 24 – 120 Hz, dot clock: 162MHz or less HDMI/DVI-D : 25 MHz– 162MHz) |
| Scanning frequency - YPBPR (YCBCR) |
480i (525i): fH 15.73 kHz; fV 59.94 Hz, 576i (625i): fH 15.63 kHz; fV 50 Hz, 480p (525p): fH 31.47 kHz; fV 59.94 Hz, 576p (625p): fH 31.25 kHz; fV 50 Hz, 720 (750)/60p: fH 45.00 kHz; fV 60 Hz, 720 (750)/50p: fH 37.50 kHz; fV 50 Hz, 1035/60i: fH 33.75 kHz; fV 60 Hz, 1080 (1125)/60i: fH 33.75 kHz; fV 60 Hz, 1080 (1125)/50i: fH 28.13 kHz; fV 50 Hz, 1080/25p: fH 28.13 kHz; fV 25 Hz, 1080/24p: fH 27.00 kHz; fV 24 Hz, 1080/24sF: fH 27.00 kHz; fV 48 Hz, 1080/30p: fH 33.75 kHz; fV 30 Hz, 1080/60p: fH 67.50 kHz; fV 60 Hz, 1080/50p: fH 56.25 kHz; fV 50 Hz |
| Scanning frequency - Video/S-Video |
fH: 15.73 kHz, fV: 59.94 Hz [NTSC/NTSC4.43/PAL-M/PAL60] fH: 15.63 kHz, fV: 50 Hz [PAL/PAL-N/SECAM] |
| Optical axis shift - Vertical |
±60% (±50% with the ET-D75LE6, +75—+88% with the ET-D75LE90) from center of screen, powered |
| Optical axis shift - Horizontal |
±20% (±15% with the ET-D75LE6, -12—+14% with the ET-D75LE90) from center of screen, powered |
| Keystone correction range |
Vertical ± 40°, horizontal ± 15° (vertical ±40° and horizontal ±15°with the ET-DLE1/2/10/20, vertical ±22° and horizontal ±15° with the ET-D75LE5/50, vertical ±28° and horizontal ±15° with the ET-D75LE6) |
| Keystone correction range when using both the Keystone and Curved correction of the Geometric Adjustment function |
Vertical ±20°, horizontal ±15° (vertical ±8° and horizontal ±8° with the ET-D75LE5/50, vertical ±10° and horizontal ±10° with the ET-D75LE6 |
| Installation |
Ceiling/floor, front/rear |
| Terminals - SDI IN |
BNC × 1, 3G-SDI signal: SMPTE ST 424 compliant Dual-link HD-SDI signal: SMPTE ST 292 compliant SD-SDI signal: SMPTE ST 259 compliant |
| Terminals - HDMI IN |
HDMI 19-pin × 1, Deep Color, compatible with HDCP |
| Terminals - DVI-D IN |
DVI-D 24-pin × 1, DVI 1.0 compliant, HDCP compatible, for single link only |
| Terminals - DIGITAL LINK/LAN |
RJ-45 Network connection / digital link connection (video/network/serial control) compliant with PJLink (class1) ,100base-tx, Art-Net compatible Deep Color, compatible with HDCP |
| Terminals - RGB 1 IN |
BNC × 5 |
| Terminals - R, G, B |
R: 0.7 Vp-p, 75 ohms, G: 0.7 Vp-p (G: 1.0 Vp-p for sync on G), 75 ohms, B: 0.7 Vp-p, 75 ohms HD, VD/SYNC: TTL, high impedance, positive/negative automatic |
| Terminals - Y, PB, PR (Y, CB, CR) |
Y: 1.0 Vp-p (including sync signal), PB/PR (CB/CR): 0.7 Vp-p, 75 ohms |
| Terminals - S-Video signal |
Y: 1.0 Vp-p, C: 0.286 Vp-p, 75 ohms |
| Terminals - RGB 2 IN |
D-sub HD 15-pin (female) × 1 |
| Terminals - SERIAL IN |
D-sub 9-pin (female) × 1 for external control (RS-232C compliant) |
| Terminals - SERIAL OUT |
D-sub 9-pin (male) × 1 for link control |
| Terminals - REMOTE 1 IN |
M3 jack × 1 for wired remote control |
| Terminals - REMOTE 1 OUT |
M3 jack × 1 for link control |
| Terminals - REMOTE 2 IN |
D-sub 9-pin (female) × 1 for external control (parallel) |
| Power cord length |
3.0 m (9 10 in) |
| Cabinet materials |
Molded plastic |
| Dimensions (W × H × D) |
620 × 291 × 800 mm (24-7/16 × 11-15/32 × 31-1/2 inches) (without lens) |
| Weight |
Approx. 41 kg (90.4 lbs) (without lens) |
| Operation noise |
46 dB (quad lamp operation) |
| Operating temperature |
0°– 45°C (32°–113°F) |
| Operating humidity |
10%–80% (no condensation) |
| Remote control unit - Power supply |
3 V DC (AA/R6 type battery × 2) |
| Remote control unit - Operation range |
Approx. 30 m (98 5 in) when operated from directly in front of the signal receptor |
| Remote control unit - Dimensions (W × H × D) |
47.5 × 181.5 × 27.5 mm (1-7/8 × 7-5/32 × 1-3/32 inches) |
| Remote control unit - Weight |
Approx. 150 g (5.3 oz) (including batteries) |
| Supplied accessories |
Power cord with security lock (× 1), Wireless/wired remote control unit (× 1), Batteries for remote control (AA/R6 type × 2), Software CD-ROM (Logo Transfer Software, Multi Projector Monitoring & Control Software) (× 1) |
| Optional accessories |
Zoom lens (0.9 –1.1:1) - ET-D75LE6, Zoom lens (1.3 –1.7:1) - ET-D75LE10, Zoom lens (1.7– 2.4:1) - ET-D75LE20, Zoom lens (2.4 –4.7:1) - ET-D75LE30, Zoom lens (4.6 –7.4:1) - ET-D75LE40, Zoom lens (7.3 –13.8:1) - ET-D75LE8, Fixed-focus lens (0.7:1) - ET-D75LE50, Fixed-focus lens (0.36:1) - ET-D75LE90, Lens motor cover - ET-D75MC1, Ceiling mount bracket - ET-PKD520H (for high ceilings), ET-PKD520S (for low ceilings), Projector mount bracket - Projector mount bracket ET-PKD520B, Frame - ET-PFD510, Smoke cut filter - ET-SFR510, Replacement lamp unit - ET-LAD520 (one bulb), ET-LAD520F (a set of four bulbs), Replacement filter unit - ET-EMF510 |